Warnings And Guidelines - Christie Projector User Manual

4. Maintenance & Care
4.1 Warnings and
Guidelines
Labels & Markings
Protection Location
Lamp and Filter
Replacement
WARNING
Never look directly into the projector lens. The extremely high
brightness of the projector can cause permanent eye damage.
Observe and follow all warnings and instructions marked on the projector.
This symbol warns the user that the presence of uninsulated
voltage within the unit may be sufficient to constitute the risk of
electric shock. Therefore, it's dangerous to make any kind of
contact with any part inside of the projector.
This symbol alerts the user that important operation and
maintenance instructions have been provided. This information
should be read carefully to avoid problems.
"
Operate the projector in an environment which meets the operating range
specification in Section 6, Specifications. Do not operate the projector
close to water, such as near a swimming pool.
"
Do not place the projector on an unstable cart, stand or table. If the
projector is to be ceiling mounted, only use the Christie-approved ceiling
mount fixture.
"
A projector and cart combination should be used with care. Sudden stops,
excessive forces, and uneven surfaces may cause the projector and cart
combination to overturn.
"
Always turn off the power switch before replacing the lamp. Allow the unit
to cool off for at least one hour before replacing the lamp. Replacing the
lamp according to the directions in the operational manual. Burns or
electrical shock may occur if the replacement is performed incorrectly.
"
Do not tamper with the lamp interlock mechanism. Electrical shock or
other damage may occur if the interlock mechanism does not operate
correctly.
"
When the lamp is removed, handle it with care, and ensure it is not
subjected to impact. Do not use the lamp unit if it has been subjected to
shock or scratched. Contact your sales office for repair.
"
Do not touch the terminal end of the lamp unit or the screws, which secure
the connector. Even if screws become loose, do not attempt to perform the
repair operation yourself and contact your sales office. This condition may
result in fire, electrical shock or other damage.
WARNING
If you continue to use the lamp after the lamp expired message has
been displayed on the screen, the lamp bulb may shatter and pieces of
glass may scatter inside the projector and out into the room. Do not
touch glass as it may cause injury. Contact your sales office for lamp
replacement.
"
Replace the air filter every time the lamp is replaced. If this filter is not
replaced, air flow may be restricted and cause the projector to overheat.
26