Printing Area And Cut Position - Star Micronics NP-266S Product Specifications

2.2 Printing area and cut position

Cut Position
Feed direction
※ Please take care not to take the paper very hard after the partial cut, which cause heavy load on
platen and might cause the poor print quality on the head part of next line. To avoid such problem,
please take care by feeding approx. 1 mm at the beginning of print or by take the paper to the direction
to left or right.
※ The cut mode (full cut or partial cut) must be set by the factory. No change of cut mode is done by
the command setting.
A
NP-266S 432
NP-366S 576
D-F0399 NP-266S/366S Specifications Ver.0.01 Provisional
Partial cut remaining tab: approx. 2 mm (P type only)
1dot 2dots
0.125mm
B ±0.2mm
C ±1.0mm
D
B C
54 2
72 4
A dots
C ±1.0mm Approx. 3 mm feed will
0
mm
-1
D
58
80
5
Cutter to Head
Approx.13±1.0mm
(Note)
0.125mm
(Note)
take place by the
firmware, so the margin
will be 16±1mm.