Customise Beo4 - Bang & Olufsen BeoVision 4 Reference Book

32
The Beo4 buttons give direct remote
control of a large number of
television functions, and the Beo4
display gives you access to even more
functions.
Whenever a source is displayed on
Beo4 (such as TV or RADIO), you can
press the LIST button and bring up
extra functions in the display to help
you operate that source, just as if you
were calling up extra buttons. You
can also switch on extra equipment
connected to BeoSystem 2.
Note that Beo4 contains a list of all of
Bang & Olufsen's extra audio and
video functions, but only those
functions supported by BeoVision 4
work when you call them up in the
Beo4 display.
You can customise your Beo4 list of
functions to suit your needs, and
change the order in which these
extra functions appear when you call
them up.

Customise Beo4

Set up Beo4
If you have a Beo4 remote control already
you can configure the Beo4 to work with
BeoVision 4.
Press and hold the standby
button down
Press to get access to the Beo4
setup function
Let go of both buttons. ADD?
appears in the display
Press repeatedly to display
CONFIG? on Beo4
Press to be able to select the
type of configuration
Press repeatedly to display
VIDEO? on Beo4
Press to get access to the video
configuration
Press repeatedly to display
VIDEO1 on Beo4*
Press to store the configuration
STORED appears, indicating that
the configuration has been
stored. You leave the Beo4 setup
function automatically
*If the video configuration does
not contain VIDEO1, select
AVANT instead
Add an extra 'button'
When you add a new function to the Beo4
list, you can then bring up this new 'button'
in the Beo4 display.
• Press and hold the standby
button down
LIST Press to get access to the Beo4
setup function
ADD? Let go of both buttons. ADD?
appears in the display
LIST
Press to bring up the list of
CONFIG? available 'buttons' to add from.
The first 'button' appears in the
GO display, it flashes on and off
Press to move forwards or
LIST backwards in the list of all extra
VIDEO? 'buttons'
GO Press to add and place the
'button' on its preset position
or...
LIST
...press to insert the 'button' at a
VIDEO1
specific position in the list
GO
ADDED appears, indicating that
the 'button' has been added.
STORED
You leave the Beo4 setup
function automatically
•
LIST
ADD?
GO
m
p
GO
1 – 9
ADDED