Bang & Olufsen BeoVision 4 Reference Book page 30

30
If you have BeoLink installed in your
home and place BeoVision 4 in a link
room, you can operate connected
systems in the main room through
BeoVision 4.
You must follow the procedure
described below when you connect
BeoVision 4 for use in a link room:
1 Connect BeoSystem 2 to the mains.
2 Using the Beo4 remote control,
program BeoSystem 2 to Option
6*.
3 Disconnect BeoSystem 2 from the
mains.
4 Make the connections.
5 Reconnect BeoSystem 2 to the
mains.
BeoLink – BeoVision 4 in a link room
Option setting
For your entire system to function properly, it
is essential that the BeoSystem 2 in the link
room is set to the correct Option before you
connect it to the system in the main room!
> While holding down the • button, press LIST.
> Let go of both buttons.
> Press LIST repeatedly to display OPTION? on
Beo4, and press GO.
> Press LIST repeatedly to display V.OPT on Beo4,
and press 6*.
Link room connections
Your BeoSystem 2 in the link room must be
connected to your main room system using
two different cables:
– BeoLink connection (using a Master Link
cable and a junction box).
– Aerial connection (using an ordinary aerial
cable).
BeoLink connection
In the main room: Connect the Master Link
cable to the socket marked MASTER LINK on
the main system. Run the cable to the junction
box, and cut the cable to an appropriate length.
In the link room: Connect the Master Link cable
to the socket marked MASTER LINK on
BeoSystem 2. Run the cable to the junction box,
and cut the cable to an appropriate length.
Inside the junction box: Join the cables as
explained in the Guide enclosed with the box/
cable. This Guide explains all the possibilities for
the box, and how to join the cables.
Aerial connection
Using an ordinary TV aerial cable (coaxial cable),
connect one end to the socket marked LINK on
the main system, and the other end to the aerial
input socket on BeoSystem 2.
Main room Link room
*If you connect BeoVision 4 for use in a link room
where other link systems are already connected,
such as speakers, you must program BeoSystem 2
to 'Option' 5 instead.
Option 6