Bang & Olufsen BeoVision 4 Reference Book page 29

System modulator
If you have an audio system or a link speaker
in a link room and you choose to set up a
non-linkable television in the same room, you
must set the system modulator to On. The
factory setting is Off.
Tuning
1 TV
3 Link frequency
Tuning
1 TV
3 Modulator
Modulator
On
To switch on the system modulator...
> Press MENU to bring up the main menu.
> Press 3 to bring up the Setup menu. Tuning is
already highlighted.
> Press GO to bring up the Tuning menu.
> Press p to move the cursor down to the
Link frequency menu.
> Press MENU to reveal the item Modulator.
> Press GO to bring up the Modulator menu.
> Press m or p to change from Off to On.
> Press GO to store the setting, or...
> ...press EXIT to leave all menus without storing.
Link frequency
If, for example, a TV channel in your area is
broadcasted on the same frequency as the
BeoLink system uses, 599 MHz, you must tune
the system modulator to an unoccupied
frequency. When you change the link
frequency in the main room system, make
sure that the link frequency in the link room
system corresponds.
Tuning
1 TV
3 Link frequency
Frequency
599
To change the link frequency...
> Press MENU to bring up the main menu.
> Press 3 to bring up the Setup menu.
> Press GO to bring up the Tuning menu.
> Press 2 to bring up the Link frequency menu.
> Press m or p to find an available frequency.
Alternatively, key in the frequency using the
number keys on Beo4.
> Press GO to store your setting, or...
> ...press EXIT to leave all menus without storing.
29