Bang & Olufsen BeoVision 4 Reference Book page 11

ON/OFF
RGB
IR-IN
RS232
S-VHS
VIDEO
R
L
0/12 V CONTROL
PHONES
FAN
MAINS
Socket panel – plasma screen
The socket panel on the back of the screen
contains sockets for connection to BeoSystem 2.
DVI
Socket for connection of a High Definition video
source or a PC.
PC IN
Socket for connection to the RGB socket on
BeoSystem 2.
SERIAL
Socket for connection to the RS232 socket on
BeoSystem 2.
For the installer...
When connections are complete, you must select
the screen type in a Service menu.
While BeoVision 4 is on...
> Press MENU to bring up the main menu.
> Press p to highlight Setup and press GO.
> Press 0 twice, followed by GO. The Service
menu appears.
> Press 1 to bring up the Monitor menu.
> Press p to highlight Plasma version setup, and
press GO.
> Press m or p to select the screen type and press
GO to store it.
> Press EXIT to leave the menu.
> Press • to switch off the system.
DVI PC IN
IMPORTANT! If you wish to connect a computer
to the screen and use the screen as a monitor,
make sure that BeoSystem 2, BeoVision 4, the
computer, and all equipment connected to the
computer are all disconnected from the mains
before you connect the computer and the screen
to each other. In addition, the computer must be
connected to a grounded wall outlet as specified
in the computer's setting-up instructions.
11
SERIAL