Bang & Olufsen BeoVision 4 Reference Book page 19

Connect a set-top box* to the V.TAPE,
AV or DECODER sockets on
BeoSystem 2. If the sockets are all in
use, you can also connect a set-top
box to BeoSystem 2 via the close-up
socket panel.
It is also possible to connect a
decoder to either the DECODER or
the AV socket on BeoSystem 2.
Make sure that all connected
equipment is registered in the
Connections menu. For further
information, refer to the chapter
'Register and use additional video
equipment' on page 32 in the Guide.
If you have a High Definition (HD)
set-top box, refer to page 22 for
information about connection and
registration.
*NOTE! Set-top boxes must be set up in accordance
with the documentation enclosed with them.
Connect a set-top box or decoder
Set-top box (DTV or V.AUX)
AV
connection
IR transmitter
connection
BeoSystem 2
Set-top box connection
Disconnect all involved systems from the mains
before you connect external equipment. Use
the 21-pin AV cable to connect the set-top box
to BeoSystem 2:
> Connect one socket to the set-top box.
> Run the cable to the V.TAPE, AV or DECODER
socket on the back of BeoSystem 2.
> Connect the IR transmitter to the IR OUTPUT
socket on BeoSystem 2.
> Fasten the IR transmitter to the IR receiver of
the set-top box.
To be able to use the remote control included with
your set-top box, do not cover its IR receiver
entirely.
Secondary set-top box
STB(V.AUX)
Primary set-top box
STB(DTV)
IR transmitter
connection
If you connect two set-top boxes...
You will need an IR Y-adaptor (index number
6174171) to connect two set-top boxes to
BeoSystem 2. Please contact your Bang & Olufsen
retailer. Follow the procedure described below to
connect two set-top boxes to BeoSystem 2:
> Connect your primary and secondary set-top
boxes to the AV and DECODER sockets on
BeoSystem 2 (or the DECODER and V.TAPE
sockets if you have connected equipment to the
AV socket) via 21-pin AV cables as shown.
> Connect the IR Y-adaptor to the IR OUTPUT
socket on BeoSystem 2.
> Connect the IR transmitter for your primary set-
top box to the chrome-coloured socket on the
IR Y-adaptor, and fasten the other end to the IR
receiver on your primary set-top box.
> Connect the IR transmitter for your secondary
set-top box to the gold-coloured socket on the
IR Y-adaptor, and fasten the other end to the IR
receiver on your secondary set-top box.
> Register your primary set-top box in the
Connections menu as STB (DTV) and your
secondary set-top box as STB (V.AUX).
19