Table of Contents
Advertisement
DVG-5112S User's Manual
Instructions
FXS Port: When you have set the password in WEB-GUI with English character. To access DVG-5112S
IVR function is different. Instead of **[password]#. You should press ***[password]#. The character to
number conversion can be acquired from PPPoE Character Conversion Table.
Example:
1. The factory default code is blank. Enter
code. Please refer to IVR Function Table for IVR function code.
2. if the password is 1234, then enter
3. If your password is abc123 then you access IVR by pressing ***414243010203# .
FXO Port: To use IVR functions, dial the phone number of FXO Port using an external line. You will hear
the prompt "enter value", and then enter a PIN number. The factory default code is blank. Enter "**#" as
above. You are now in IVR setting mode.
Once the first setting or query has been completed, you will hear a dial tone. Then use the same
procedure to make a second query or setting. To exit IVR mode, simply hang up the phone.
Example:
**#
1. Enter
. You are now in IVR setting mode.
2. Enter 101 (to query IP address) . DVG-5112S responds with an IP address.
3. You can continue with more settings or queries: enter 111 (to set IP address)
number).
Save Settings
After entering IVR mode, dial 509 (Save Settings). Wait for about 3 seconds and after hearing a confirmation
tone "1", hang up the phone. Please reboot DVG-5112S to enable the new settings.
To inquire about current DVG-5112S's WAN Port IP address
After entering IVR mode, dial 101. DVG-5112S will repeat the current WAN Port IP address.
If DVG-5112S does not repeat the IP address, it indicates that DVG-5112S is not currently connected to the
Internet. Please check if the cable connection, account number, and password are correct.
D-Link Systems, Inc.
**#
. You are now in IVR setting mode, enter the IVR function
**1234#
.
enter 192*168*1*3 (IP
64
Advertisement
Table of Contents
