D-Link DVG-2032S Quick Installation Manual
Fxs voip gateway
Hide thumbs
Also See for DVG-2032S:
- User manual (75 pages) ,
- Quick installation manual (23 pages) ,
- User manual (65 pages)
Advertisement
This product can be set up using Internet
Explorer or Netscape Navigator, 6.x or
above, with Javascript enabled
Before You Begin
You must have the following:
‧ A subscription with the service provider included in this package
‧ A Computer with a CD-ROM drive and an Ethernet port running Windows
‧ Ethernet-based broadband modem
Check Your Package Contents
If any of the items below are missing, please contact your reseller.
These are the items included with your DVG-2032S purchase:
©2006 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of
their respective holders. Software and specifications subject to change without notice. DVG-2032S FXS
VoIP Gateway
DVG-2032S FXS VoIP Gateway
Centronics Cable x 2
CAT5 Ethernet Cable
CD-ROM
AC Power Cord
DVG-2032S
FXS VoIP Gateway
Advertisement
Table of Contents
Related Manuals for D-Link DVG-2032S
Summary of Contents for D-Link DVG-2032S
-
Page 1: Before You Begin
Centronics Cable x 2 CAT5 Ethernet Cable CD-ROM AC Power Cord ©2006 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and specifications subject to change without notice. DVG-2032S FXS VoIP Gateway... -
Page 2: Hardware Overview
Hardware Overview Front Panel WAN Port Connects to your broadband modem using an Ethernet cable. WAN LED When a connection is established, the 10 or 100 LED will light up. The LED will blink to indicate activity. If the 10 or 100 LED does not light up when a cable is connected, verify the cable connections and make sure your devices are powered on. -
Page 3: Rear Panel
Rear Panel RJ-21 Connect up to thirty-two phones using (included) Connector Centronics cables. to Phone Ports Power Used to turn the unit on and off. Switch AC Input The power cord connects here. - Page 4 Modem and Computer If your computer connects directly to a DSL or Cable modem and does not connect to a router, follow the steps below to install your DVG-2032S. For any other configuration, please refer to the user manual located on the CD-ROM.
- Page 5 Connecting the DVG-2032S directly to a Modem and Computer (continued) e. Connect one end of the Ethernet Cable provided in this package to the LAN or Ethernet Port on the Cable/DSL Modem. Connect the other end of the provided Ethernet Cable to the WAN Port of the DVG-2032S.
-
Page 6: Pppoe Configuration
PPPoE Configuration Some Internet Service providers use PPPoE as their method of connecting clients. If you have a PPPoE connection, you must follow the steps below to complete the configuration of your hardware. If you are unsure of your connection type or do not know your username and password, please check with your Internet Service Provider. - Page 7 Once the unit reboots you will see a message. Check to see if the status LED light goes from blinking green to solid green on the front panel of the DVG-2032S. The information displayed on the Device Information page is necessary for VoIP service...
Need help?
Do you have a question about the DVG-2032S and is the answer not in the manual?
Questions and answers