VideoBloX MODULES
11. Enter the old password in Old Password textbox and new password in New
Password and Confirm New Password textboxes. Then click Apply.
Figure 2-19
Figure 2-19 Changing Password Success
NOTE: Characters in password of NETCPU and NETOSD can be numbers, letters or
symbols. And it should include no more than 20 characters.
NOTE: In case that you forget the password, set SW8 of switch 2 to "1" to reset
password to default value (hvs). Refer to
information.
12. To logout this software, click Logout on the right upper part of the web page.
NETOSD Firmware Upgrade
Perform the following steps to upgrade NETOSD firmware.
1. Enter the IP address in the Internet Explore address bar and press Enter. Then the
Login page
Figure 2-20 Login Page
20
will be displayed if password has been changed successfully.
(Figure 2-20
) is displayed.
DIP Switch Settings
on page
10
for detailed