Figure 3-18 Alarms - General Configuration - Honeywell VideoBloX User Manual

SYSTEM CONFIGURATION
Alarms can be used in simple applications to start a Sequence thus switching a camera
to a monitor, displaying text on a screen, activating a control output, sounding a keyboard
alarm, and "flashing" an Icon on an associated GUI (Graphical User interface).
Alarms can also be assigned to an Alarm Queue.
The fields necessary to configure Alarms are on the Alarms screen.
Figure 3-18 Alarms – General Configuration
Heading
Field Definitions
Field
HEADER
Alarm Number
DESCRIPTION
Alarm Name
Short Name
ENABLED
CONTACT OPEN
Enabled
68
Physical address of the Alarm Input as determined by the
device it is connected to (Alarm 1-6000 are on GPIO
address 1-250, Alarm 6001-6256 are on alarm concentrators
1-16).
The name assigned to this alarm channel.
Short name assigned to this alarm channel.
Check the box to enable monitoring of this alarm input.
Leaving the box unchecked is a quick method of disabling
an alarm producing erroneous signals.
When this box is checked, the Sequence is activated when
the Contact Opens.
Description
General tab