Figure 3-44 Vst Dvr Control - Honeywell VideoBloX User Manual

-
-
•
-
-
-
-
VST DVR Control

Figure 3-44 VST DVR Control

•
-
-
-
-
Honeywell Ademco MUX Control
Keyboard Function buttons (Record, Pause, Rewind, Forward, Play, and Stop)
control VCR.
On completion of a review by an operator, the operator should ensure that the
tape is wound to the correct position before setting the VCR back into record
mode.
VCR monitoring and Re-routing System
When a VCR is recording, the view will show an asterisk (*).
If the VCR is stopped (by an operator, tape change, or VCR fault), the view will
show the standby VCR which is recording the view (i.e., [1234 -> 3025]).
If there are no standby VCRs, recording of the view will be lost and the view will
show [No backup VCR].
VCRs which are not recording (and re-routed) can be viewed as a list on any
monitor using the diagnostic output.
VST – Number
The VST recording is only available on the working monitors.
The VST number to control corresponds to the monitor number.
Keyboard Function buttons (Record, Pause, Rewind, Forward, Play, Stop)
will control VST recorder
A VST recorder has no standby recorder and it continues to record while a
review is in progress.
Honeywell
101