Table 15: Print Report Commands - Bosch K2200 Series User Manual

K2200 Series | User Guide | 5.0

Table 15: Print Report Commands

Command Description
P1 Personnel
Door Data
P2
Access Codes
P3
System Status
P4
Transactions
P5
System Set up
P6
P7 Alarm Data
P8 Time Profiles
P9 Holiday Profiles
The P2, P4 and P6 commands will start printing
immediately; for other commands, see below.
5. The commands P1, P3, P7 P8 and P9 ask for a
FROM and TO parameter.
PRINT FROM 1
PRINT TO 4000
(P1 – Personnel)
The default values are FROM 1, and TO the
highest value (P1: 4000, P3:128, P7: 128, P8: 32,
P9: 24).
Press [ENT].
Press [NXT] to go to the TO field.
Press FastFind (*) at any point to accept the
entered values and start the report.
6. P5 – Transactions - asks for a start date and
time plus an end date and time. The defaults are
the earliest possible date and time and the
current date and time.
STRT DT 00-00-00
STRT TIME 00-00
END DT 11-11-93
END TIME 17-13
Use [NXT] to enter any other date and time as
the report range.
Press [ENT] after making any changes.
Press FastFind (*) at any point to accept the
entered values and start the report.
7. Printing - If the printer is connected, a scrolling
display will appear indicating that the report is
being printed.
*PRINTING PERSON
Press [ESC] at any time to abort the printout.
Bosch Security Systems | 7/03 | 17376 v1.1 / 47491C
Displays, Alarms, and Printing
Note:
The personnel (P1) may appear to spend a long time
showing this display but not printing. This is because it
examines all 4000 possible keyholders for valid entries,
unless the upper limit is reduced
8. Failure to Print - If the printer is not connected
or out of paper, you may get this message, plus a
short beep.
PRINTER FAULT
Reconnect the printer or fill it with paper and try
the command again.
EN | 33