Table of Contents
Advertisement
K2200 Series | User Guide | 7.0
7.0 Troubleshooting
This section is designed to help you "troubleshoot"
problems that may occur. Once the system has been
installed and commissioned, the majority of the
problems that are likely to occur will be due to
incorrect programming of the system. Any hardware
problems that may arise (broken cable, faulty reader,
etc.) have already been dealt with in the Readykey
K2200 Series Controllers Installation Guide (Bosch P/N:
46513, PAC P/N: 17375).
Many common problems involve programming the
system. A flowchart is provided for each problem,
which takes you through a series of checks that
should resolve the problem. The note "installer"
means that it may be a hardware fault and you
should refer to Readykey K2200 Series Controllers
Installation Guide (Bosch P/N: 46513, PAC P/N: 17375).
Where instructions are given (e.g. add access group),
refer to the appropriate section of this document for
details.
The following problems are covered:
Key not working - access not allowed through
one of the doors in the system.
No access to Editor mode.
User cannot add/delete keys etc.
Note:
It is assumed that the system has been commissioned
and tested and all installation problems resolved.
7.1
End User Troubleshooting
7.1.1
Key Not Working
Note:
This section is primarily for use with standalone
systems. Troubleshooting for networked systems is
primarily via Readykey for Windows. However, for
completeness, troubleshooting for the Windows system is
also included here
. When a key is presented within range of the reader the
LED will flash green momentarily to indicate the code
in the key has been read. If the key is valid for that door
at that time, the LED will turn green and the lock will
operate. The LED will stay green while the lock is
released.
Bosch Security Systems | 7/03 | 17376 v1.1 / 47491C
Troubleshooting
EN | 51
Advertisement
Table of Contents
