THE 828MKII SETTINGS
828mkII settings in Mac OS 9
In Mac OS 9, the 828mkII settings can be accessed
by choosing MOTU Audio System
options>Configure Hardware Driver from the
Basics menu. This is where you choose the
828mkII as your audio input output device. Once
you've done so, you should see the 828mkII
settings as shown below in Figure 9-1.
Figure 9-1: The 828mkII settings.
66
828mkII settings in Mac OS X
In Mac OS X, choose the 828mkII as your audio
input output device by choosing MOTU Audio
System options>Configure Hardware Driver from
the Setup menu. This window shows some of the
828mkII settings, such as sample rate and clock
source, but to access all of the 828mkII settings,
open the MOTU FireWire Audio Console, as
shown in Figure 5-1 on page 42.
Figure 9-2: Under Mac OS X, choose Setup menu> Configure Audio
System> Configure Hardware Driver to open the dialog shown above
and access the 828mkII CoreAudio driver. To access the rest of the
828mkII settings, open the MOTU FireWire Audio Console.
A U D I O D E S K