Assigning Outputs - MOTU 828mkII User Manual

ASSIGNING OUTPUTS

Once you've chosen the MOTU FireWire ASIO
driver in the Audio System dialog as explained
earlier in "Choosing the MOTU FireWire ASIO
driver" on page 81, 828mkII outputs will be
available in Cubase or Nuendo as output
destinations. In Cubase VST, these outputs appear
in the VST Master Mixer window as output
In Cubase VST, use the output buttons at the bottom of each channel strip, including the master fader, to assign 828mkII
outputs to busses. You can then assign channels in the VST Master Mixer window to each bus as desired.
In Nuendo, access the 828mkII outputs via the busses in the VST Outputs window.
Figure 11-7: Working with 828mkII
outputs in Nuendo or Cubase.
C U B A S E , N U E N D O A N D O S 9 A S I O S O F T W A R E
assignments for the master fader and busses, as
shown below in Figure 11-7.In Nuendo, they
appear in the VST Outputs window.
The "Phones 1-2" output
If you've chosen to treat the 828mkII headphones
as an independent output, you'll see Phones 1-2 as
an 828mkII output destination. Audio tracks
85