This section contains step-by-step disassembly procedures for the PowerMate CT 815 system. A
disassembly figure is provided with most procedures. Section 5 includes a field-level parts list
and an illustrated parts breakdown showing an exploded view of the system.
For complete disassembly of the system, follow the disassembly order listed in the following
table. For disassembly of a specific part, locate the part in the following table and go to the page
referenced. To reassemble, follow the table and procedures in reverse order. Where reassembly
is not readily apparent, reassembly procedures are provided.
A small flat head screwdriver and a small Phillips-head screwdriver are the only required tools.
Note
Included at the end of this section are procedures for converting the minitower system
to a desktop system and a desktop system to a minitower system. Performing the conversion
requires use of several disassembly procedures contained in this section.
Sequence
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
----
When disassembling the system, follow these general rules.
Turn off the system and disconnect the AC power cord from the power source and system
!
unit.
Disconnect all peripherals before disassembling the system.
!
Before opening the system or handling boards or chips, touch the system's metal chassis to
!
discharge static.
Do not disassemble parts other than those specified in the procedure.
!
3-2 Disassembly and Reassembly
PowerMate CT 815 Disassembly Sequence
Part Name
Expansion Board Retainer Bar
Minitower and Desktop Conversion
See Page
3-4
3-6
3-8
3-9
3-11
3-13
3-16
3-21
3-24
3-27
3-28
3-29
3-29
3-30
3-31
3-32
3-33