Internal Cable Connectors
Locations of the internal cable connectors on the system board are shown in the following
figure.
A – CD Audio In
B – IDE Secondary Connector
Jumper Settings
The following sections provide the names and locations of jumpers on the system board, and
provides procedures for changing a jumper setting.
Locating Jumper Blocks
The system board has six configuration jumper blocks:
CMOS Clear JP18
!
BIOS Recovery JP15
!
Rear USB Device Wake Up JP1
!
PS/2 Keyboard at Power On JP3
!
Front USB Keyboard Wake Up JP31
!
Save to RAM JP4.
!
Use the following figure to locate the jumper blocks on the system board.
The factory-set jumper settings are included in Section 2, "System Configuration."
System Board Internal Cable Connectors
C – IDE Primary Connector
D – Diskette Drive Cable Connector
System Board 4-3