A – Battery
With the positive (+) side of the new battery facing up, press the battery into the socket.
6.
Replace the system cover.
7.
Connect external peripherals and power cables, and power up the system.
8.
Run the Setup Utility to reconfigure your system parameters (see "BIOS Setup Utility" in
9.
Section 2).
Front USB Port
Remove the front USB port as follows.
Remove the system cover and front panel (see "Removing the Cover" and "Removing the
1.
Front Panel").
Disconnect the front USB port cable from its header on the system board.
2.
Remove the two screws that secure the USB port to the front of the chassis. Save the
3.
screws.
Gently pull the board off the chassis and feed its cable through the cutout in the front of the
4.
chassis. Set the board aside.
3-28 Disassembly and Reassembly
Removing the Battery
Locating Front USB Port Screws
A – Screw
B – Clip
B – USB Port Board