Locating The Device Rails And Screws; Installing A 5 1/4-Inch Device For Use In A Minitower - NEC POWERMATE CT 815 Service And Reference Manual

Determine if the device being installed is a master device or a slave device on the primary
4.
or secondary channel (see the documentation that comes with the device and the table "IDE
Cable Configurations"). Set the device jumpers accordingly.
Position the device so it is right side up for the minitower or desktop orientation (see the
5.
following figure).

Installing a 5 1/4-Inch Device for Use in a Minitower

Slide the device into the empty bay until it clicks in place.
6.
Connect the signal and power cables to the back of the device.
7.
Locate an unused signal connector on the primary or secondary interface cable and plug
!
it into the connector on the back of the device. (See the following figure, "Locating
System Board Cable Connectors," for IDE cable connector locations.)
Locate an unused power cable of the proper length and plug its connector into the
!
power connector on the back of the device.
If installing a CD-ROM, CD-RW, or DVD-ROM drive and there are speakers, connect the
8.
drive's audio cable to the CD IN connector on the system board or optional sound board.
Replace the front panel and the cover.
9.
3-20 Disassembly and Reassembly

Locating the Device Rails and Screws

A – Screw or Locking Pin B – Device Rail