Troubleshooting - 3D Printing Systems UP Plus 3D Manual

4. Load the spool of filament of filament onto the roll holder, with the
filament coming out from the back of the roll / printer. filament coming out from the back of the roll / printer.
5. Feed the end of the filament Feed the end of the filament through the filament guide.
Feed the filament through the feeder
about 10cm out the other end of the tube. about 10cm out the other end of the tube.
6. Push the end of the filament into the print head feed Push the end of the filament into the print head feed
hole.
7. Place the Perfboard the Perfboard on top of the black platform and
attach the binder clips attach the binder clips on the front in order to hold the
Perfboard in place. (as per picture)
Perfboard after printing after printing to remove printed models from
the printer. When printing starts, melted plastic will be When printing starts, melted plastic will be
pushed into the holes of the Perfboard. pushed into the holes of the Perfboard.
8. Plug the USB cable into the Plug the USB cable into the back right of the printer.
9. Plug in the power adapter Plug in the power adapter and USB into the back of the
printer.
10. Switch on at the wall socket Switch on at the wall socket and switch on at the back
of the printer.
11. Visit www.3dprintingsystems.com/support www.3dprintingsystems.com/support
and install the 3D Print Software. and install the 3D Print Soft
12. Installing the drivers (Windows) Installing the drivers (Windows)
UP Plus 3D Printer User Manual 3D Printer User Manual
through the feeder tube and feed
(as per picture) Always remove the
to download

4. Troubleshooting

Troubleshooting
Top View Top View
Chapter 3.1.2 Installing the 3.1.2 Installing the
Chapter 3.1.3 Installing drivers 3.1.3 Installing drivers
v 2013.6.10
software
(Windows)