3D Printing Systems UP Plus 3D Manual page 30

quantity should be set to 700 grams. You can also specify whether the material you are printing quantity should be set to 700 grams.
with is ABS or PLA.
TIP: An empty spool weighs about 280 grams so, if you are installing a partially used spool, An empty spool weighs about 280 grams so, if you are installing a partially used spool, An empty spool weighs about 280 grams so, if you are installing a partially used spool,
weigh it, and subtract 280 grams from the weight. This gives you the value to enter into the mat 280 grams from the weight. This gives you the value to enter into the mat 280 grams from the weight. This gives you the value to enter into the mate-
rial text box.
Status: Displays the temperature of the temperature of the nozzle and platform.
Stop All: Stops heating and all the movement of the printer. Once heating and all the movement of the printer. Once you click this button, the
model being printed is cancelled cancelled. You CANNOT resume a print job once the printer has been
stopped. After you use the "Stop All" option, you will need to re After you use the "Stop All" option, you will need to re-initialise the printer.
Pause Print: This button allows you to pause a print in mid This button allows you to pause a print in mid-progress, you can
print job where it left off. This is very useful if you, for example, want to change the material col- print job where it left off. This is very useful if you, for example, want to change the material co print job where it left off. This is very useful if you, for example, want to change the material co
our mid-print. Another popular use for pausing a job mid print. Another popular use for pausing a job mid-print is to allow fasteners to be inserted
into printed cavities and then printed over to lock the fastener into place. Note: This keeps the e into printed cavities and then printed
truder and platform heating during the pause, it's not recommended to pause for long periods of truder and platform heating during the pause, it's not recommended to pause for long periods of truder and platform heating during the pause, it's not recommended to pause for long periods of
time.
Nozzle & Platform: The five buttons
and the platform. The nozzle moves to the left and right; the platform moves forward and back- and the platform. The nozzle moves to the left and right; the platform moves forward and bac and the platform. The nozzle moves to the left and right; the platform moves forward and bac
ward.
The "To" button controls the height of the platform
procedure described in 3.3.2.
The "Bottom" button returns the platform to the lowest position.
Set Nozzle Height: Takes whatever value you have in the "To" box and transfers it to the Nozzle Takes whatever value you have in the "To" box and transfers it to the Nozzle Takes whatever value you have in the "To" box and transfers it to the Nozzle
box of the setup screen.
UP Plus 3D Printer User Manual 3D Printer User Manual
You can also specify whether the material you are printing
You CANNOT resume a print job once the printer has been
ive buttons (FL, FR, Center, NL, NR) control the position of the
the height of the platform, and is used in the nozzle height calibration
the platform to the lowest position.
4. Troubleshooting Troubleshooting
click this button, the current
the printer.
u can then resume the
print is to allow fasteners to be inserted
This keeps the ex-
position of the nozzle
used in the nozzle height calibration
v 2013.6.10