3D Printing Systems UP Plus 3D Manual page 15

22. Select the following: the following:
Z Resolution: "0.2mm" "0.2mm"
Fill: Hollow Honeycomb (bottom right) Hollow Honeycomb (bottom right)
Support Angle: 30 degrees 30 degrees
Typically these are the only values you'll need to these are the only values you'll need to
change.
Click "OK"
23. Select the overall print quality Select the overall print quality
Normal = Average quality = Average quality
Fine = Good quality and takes longer = Good quality and takes longer
Fast = Draft quality and takes less time = Draft quality and takes less time
Now click "OK" to start your first print! Now click "OK" to start your first print!
24. The software will now spool the print job to printer. The software will now spool the print job to printer.
Once finished spooling, the printer will Once finished spooling, the printer will beep, you can
then disconnect the USB cable from your computer if then disconnect the USB cable from your computer if
you wish.
25. The printer will now start to preheat the The printer will now start to preheat the platform and
the extruder. You can watch the temperature raise by the extruder. You can watch the temperature raise by
clicking "3D Print" and "Maintenance" clicking "3D Print" and "Maintenance"
26. Make sure the extruder vent extruder vent door is closed (turn lever
to the right). This is located on the left side of the e This is located on the left side of the ex-
truder print head. Having the door closed with speed up
pre-heating time on both the extruder head and the heating time on both the extruder head and the
heated platform.
27. Once the printer has finished printing e the printer has finished printing remove the part
and break away the support material. and break away the support material.
3.1.2 Installing software 3.1.2 Installing software
Visit
and install the software.
Windows: Start the UPx.xx setup.exe file and install it to the specified directory (Default is Start the UPx.xx setup.exe file and install it to the specified directory (Default is Start the UPx.xx setup.exe file and install it to the specified directory (Default is "Pro-
gram files/UP" or for 64bit computers Program files x86 " or for 64bit computers Program files x86\UP"). Note: This installs the UP software,
the UP drivers, and the UP sample files into your Program files/UP folder. the UP drivers, and the UP sample files into your Program files/UP folder.
UP Plus 3D Printer User Manual 3D Printer User Manual
Having the door closed with speed up
to download the latest software for MAC and Windows to download the latest software for MAC and Windows
4. Troubleshooting Troubleshooting
Chapter 3.3.6 Print Preferences Chapter 3.3.6 Print Preferences
Chapter 4. Printing Chapter
Chapter 4.1 Extruder Vent Chapter 4.1 Extruder Vent
lls the UP software,
v 2013.6.10