Operation - 3D Printing Systems UP Plus 3D Manual

3. Operation

3.1.1 Quick Setup Quick Setup
two
1. Remove the packing clips that hold the extruder head packing clips that hold the extruder head
and platform in place during shipping. in place during shipping.
2. Attach the "roll holder roll holder / feeder guide" onto the left side
of the printer using the middle sized included alan key. using the middle sized included alan key.
Remove screw (b) and attach the roll holder as per Remove screw (b) and attach the roll holder as per
diagram and attach with screw (b) diagram and attach with screw (b)
3. Open the foil bag that contains Open the foil bag that contains the ABS filament.
UP Plus 3D Printer User Manual 3D Printer User Manual
4. Troubleshooting Troubleshooting
NOTE:
Do not let go of the end of the filament, Do not let go of the end of the filament,
otherwise it will unravel unravel itself and tie itself in a knot,
which will then cause a block in the extruder head and which will then cause a block in the extruder head and
several hours of unwinding the spool manually to find several hours of unwinding the spool manually to find
the knot!
v 2013.6.10