3D Printing Systems UP Plus 3D Manual page 38

The lever that is located on the extruder vent "Wind barrier" does the following: The lever that is located on the extruder vent "Wind barrier"
Door Closed
Each printed layer bonds to the previous Each printed layer bonds to
•
layer better, making for a making for a stronger part.
The under sides of printed curves have a The under sides of printed curves have a
•
rougher finish.
Recommend for large parts. Recommend for large parts
•
Support material is harder to remove. Support material is harder to remove.
•
The heated platform is not affected by The heated platform is not affected by
•
the airflow, so reduces warping of the the airflow, so reduces warping of the
raft from the platform. Having the door raft from the platform.
open during pre-heating can cool the heating can cool the
platform unevenly thus resulting in platform unevenly thus resulting in
warping.
The above is a heat temperature temperature map image after 20 minutes of preheating. As the heater is located
in the centre below the platform, it takes a while for the heat to reach the corners. It is best to i in the centre below the platform, it takes a while for the heat to reach the corners. It is best to in- in the centre below the platform, it takes a while for the heat to reach the corners. It is best to i
sulate the platform during pre-
UP Plus 3D Printer User Manual 3D Printer User Manual
Door Open
• Each printed layer bonds to the previous Each printed layer bonds to the previous
layer less, making for a weaker part.
• The under sides of printed curves have a The under sides of printed curves have a
smoother finish
• Recommend for small and intricate
• Support material is easier to remove.
• Delaminating can occur in the model, try Delaminating can occur in the model, try
with the door closed.
• Recommend to keep the door closed during
pre-heating of the platform, and open the
door after the raft section has been co
pleted to reduce chances of warping. pleted to reduce chances of warping.
• Recommended open with the
ments
-heating especially when printing large parts.
4. Troubleshooting Troubleshooting
less, making for a weaker part.
small and intricate parts
to remove.
to keep the door closed during
heating of the platform, and open the
t section has been com-
with the
. As the heater is located
v 2013.6.10
Value Fila-