Troubleshooting - 3D Printing Systems UP! Desktop User Manual

4. Troubleshooting

8. Troubleshooting
Problem or error
message
No power
Extruder or platform
fails to reach operating
temperature
Material not extruding
Cannot communicate
with printer
Others
UP! 3D Printer User Manual
Solution
Verify power cord is securely plugged in.
1. Verify printer has initialized. if not, initialize the
printer
2. Heater is damaged, replace the heater
3. Check the heater cable and connector by removing
the X axis cover.
Material is stuck in the extruder. See 3.3.3 Maintain
(Extrude)
The gap is too wide between the bearing and wire feed
rollers.
1. Make sure the USB cable is connected to the printer,
and to the PC
2. Unplug the USB cable, then plug in again.
3. Reset the printer—power off then power on.
4. Restart the PC
5. Check in device manager, that the freemotion 3D
Printer driver is detected.
Contact Technical Support :
support@3DPrintingSystems.com
Support@pp3dp.com or
37