Installation Requirements And Handling - Canon Color imageRUNNER C1030 Starter Manual

Telephone Equipment
When using telephone equipment, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
1 Do not use this machine near water (i.e., near a bathtub, kitchen sink, or
laundry tub), or in a wet basement or near a swimming pool.
2 Avoid using the telephone during an electrical storm, as there may be a
remote risk of electric shock from lightning.
3 Do not use the telephone to report a gas leak in the vicinity of the leak.
Installation Requirements and
Handling
In order to use this machine in a safe and trouble-free manner, install the
machine in a place that fulfills the following conditions. Also, read the
remarks carefully.
Temperature and Humidity Conditions
‒
Temperature range: 50 to 86 °F (10 to 30 °C)
‒
Humidity range: 20 to 80 % RH (no condensation)
Protecting the machine from condensation
‒
To prevent condensation from forming inside the machine in the
following cases, let the machine adjust to the ambient temperature and
humidity for at least two hours before use.
•
When the room where the machine is installed is heated rapidly.
•
When the machine is moved from a cool or dry location to a hot or
humid location.
‒
If water droplets (condensation) form inside the machine, this can result
in paper jams or poor print quality.
When using an ultrasonic humidifier
‒
When you are using an ultrasonic humidifier, it is therefore
recommended that you use purified water or other water that is free of
impurities. If you use tap water or well water, impurities in the water will
be dispersed through the air. This can be trapped inside the machine,
causing degradation in print quality.
Power Supply Requirements
120 V to 127 V, 60 Hz
Precautions when connecting the power cord
‒
Do not connect this machine to an uninterruptible power source.
‒
Use an AC power outlet exclusively for the machine. Do not use the other
sockets of the AC power outlet.
‒
Do not plug the power plug into the auxiliary outlet on a computer.
‒
Do not use the same AC power outlet for both the machine and any of
the following equipment.
•
Copy machine
•
Air conditioner
•
Shredder
•
Equipment that consumes a large amount of electricity
•
Equipment that generates electrical noise
‒
When unplugging the power cord, keep interval of 10 seconds or more
before plugging it again.
Miscellaneous precautions
‒
The maximum power consumption of the machine is as follows.
Color imageRUNNER C1030/1030iF: Less than 1300 W, 1350 W (with
optional equipment)
‒
Electrical noise or a dramatic drop in mains voltage may cause the
machine or computer to operate incorrectly or lose data.
Installation Requirements
‒
A location with sufficient space
‒
A location with good ventilation
‒
A location with a flat, even surface
‒
A location able to fully support the weight of the machine
Do not install the machine in the following locations, as this may result in
damage to the machine.
‒
A location subject to dramatic changes in temperature or humidity
‒
A location subject to condensation
‒
A poorly ventilated location (If you use the machine for a long time or to
perform a large amount of printing in a poorly ventilated room, the
ozone or other odors generated by the machine may create an
uncomfortable working environment. In addition, chemical particles are
dispersed during printing; therefore, it is important to provide adequate
ventilation.)
‒
A location near equipment that generates magnetic or electromagnetic
waves
‒
A laboratory or location where chemical reactions occur
‒
A location exposed to salt air, corrosive gases, or toxic gases
‒
A location, such as on a carpet or mat, that may warp from the weight of
the machine or where the machine is liable to sink
Installation Space
Required installation space
* When the optional Card Reader-E1 and the optional handset is attached.
Maintenance and Inspections
‒
Follow the instructions in the caution label attached to this machine.
‒
Avoid shaking or applying a shock to this machine.
‒
To prevent the paper jam, do not turn the power ON/OFF, open/close the
operation panel or rear cover, and load/unload paper in the middle of
printing operation.
‒
Be sure to remove the toner cartridge from the machine when
transporting the machine.
‒
To avoid exposing the toner cartridge to light, place it in the protective
bag included with this machine or wrap it in a thick cloth.
‒
Do not store toner cartridges in a location subject to high temperature or
humidity or in a location with dramatic changes in temperature or
humidity.
Storage temperature range: 32 to 95 °F (0 to 35 °C)
Storage humidity range: 35 to 85 % RH (no condensation)
‒
Clean this machine regularly. If this machine becomes dusty, it may
operate improperly.
‒
Use a modular cable of 118 1/8" (3 m) or shorter in length.
‒
The communication may become unavailable depending on the
condition of local environment. In this case, contact your local authorized
Canon dealer or the Canon help line.
‒
The repairing parts and toner cartridges for the machine will be available
for at least seven (7) years after production of this machine model has
been discontinued.
51