Table of Contents
Advertisement
NetVanta 1131 RPS/EPS
Single Rackmount
Instructions for Rack Mounting the NetVanta 1131 (Single Mount)
Step
1
Securely fasten the rackmount brackets to the NetVanta 1131 using the screws provided with
the unit. The brackets can be attached in flush mount, 2-inch mount, and mid-mount positions
(see
Figure
12) depending on your installation requirements.
Important! To avoid damaging the unit when attaching the mounting brackets, use only the
screws supplied with the unit.
2
To allow proper grounding, scrape the paint from the rack around the mounting holes where the
unit will be positioned.
3
Position the unit in a stationary equipment rack either above or below the NetVanta switch.
4
Have an assistant hold the unit in position as you install two appropriate mounting bolts through
the unit's brackets and into the equipment rack.
5
Proceed to the steps given in
page
41.
.
Front Mount
Figure 12. Rack Mounting the NetVanta 1131 Using the Brackets
38
NetVanta 1600 Series Hardware Installation Guide
Action
Connecting the NetVanta 1131 and the NetVanta Switch on
2-inch Mount
Copyright © 2013 ADTRAN, Inc.
Mid-mount
61700568F1-34D
Hide quick links:
Advertisement
Table of Contents
