A Data Display Settings/Video Loss Settings - Sanyo DSR-3716 Instruction Manual

General settings
A Data display settings/VIDEO LOSS settings
These settings are used to control the operating display area
of the monitor, to display the date, time and other
information. Normally all indicators are displayed, but they
can be hidden, if needed.
"VIDEO LOSS" can be set to be displayed when a camera
video is interrupted due to an unexpected problem, or a lamp
connected to the rear panel control terminals can be turned on.
1
Display the <DISPLAY SET> screen as explained in
"Displaying the general settings screen", and then turn
the S-dial clockwise. (P62)
The "ON" indicator on the DATE line starts blinking.
MENU
(S)
(J)
2
Turn the J-dial, set the DATE to "OFF", and then turn the
S-dial clockwise.
Repeat the same procedure for each item you want to hide
from the display.
<DISPLAY SET>
1
DATE : ON
2
TIME : ON
3
QUALITY : ON
4
AUDIO : ON
3
ALARM COUNT : ON
6
ALARM TYPE : ON
7
TITLE : ON
VIDEO LOSS : ON
☞
The operating display area after setting the items
"OFF".
01-01-06 00:00:00
63 How to set
<MAIN MENU>
3. GENERAL SET
<GENERAL SET>
1.DISPLAY SET
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON
1 2 3 46 5
01-01-06 00:00:00 REC REPEAT EN A ALARM 0000
02
7
REC REPEAT EN A ALARM 0000
3
Turn the J-dial, select "VIDEO LOSS", and turn the
S-dial clockwise.
The "ON" field starts blinking.
Normally this is set to display. If necessary, turn the J-dial
and hide it by setting it to "OFF".
(S)
(J)
4
Turn the S-dial clockwise.
5
Press the EXIT/OSD button.
EXIT/OSD
☞
Cancelling the VIDEO LOSS detection
• Connect a normal video signal.
• If video signal connection is not necessary, then press the
camera selection button where the VIDEO LOSS was detected,
and then press the same camera selection button again for
about 3 seconds.
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON