Assembly - Healthrider Crosstrainer 2000s Elliptical User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a phillips screwdriver
spanners
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 28
and 29. The number after the parentheses is the quantity used in assembly. Note: Some small parts may have
been preassembled. If a part is not in the parts bag, check to see if it is preassembled.
M6 Washer
M8 Split
(64)–2 Washer (110)–4
M4 x 16mm M6 x 16mm Patch
Screw (98)–4 Screw (76)–4
M8 x 44mm Button Screw (84)–8
M8 x 38mm Button Bolt
(105)–2
1. Identify the Front Stabiliser (8). Whilst another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabiliser to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (104).
Whilst another person lifts the rear of the Frame
(1), attach the Rear Stabiliser (not shown) to the
Frame in the same way.
, a rubber mallet
M8 Washer
(66)–4 Washer (73)–2
M8 x 62mm Button Screw (83)–4
, and pliers
M10 Washer
M10 Split
(58)–2
M10 x 79mm Bolt Set (65)–2
M10 x 108mm Button Screw (70)–2
1
104
5
, two adjustable
.
M4 x 12mm
Round Head
M8 Jam Nut
Screw (96)–1
(86)–6
M8 x 41mm Button
Bolt (85)–4
1
8
84
84
4, 5