Assembly - Healthrider CROSS TRAINER800s User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver
mallet .
See the drawings below to identify the small parts needed for assembly. The number in parenthesis below
each drawing is the key number of the part, from the PART LIST on page 14. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a
part is not found in the parts bag, check to see if it has been pre-assembled.
M8 Split
Washer (74)–3
Washer (17)–4
M4 x 16mm
Screw (66)–4
M8 x 25mm Button
Screw (57)–3
M8 x 42mm Button
Bolt (50)–4
M8 x 50mm Button
All manuals and user guides at all-guides.com
M8 Large M10 Split
Washer (67)–8
M4 x 19mm M8 x 19mm Button
Screw (39)–2 Screw (22)–4
M10 x 22mm Button
Screw (21)–4
Screw (20)–4
, two adjustable spanners
M16 Wave
Washer (87)–2
M8 Nylon
Locknut (46)–4
Bolt Set (27)–2
M10 x 105mm Carriage
Bolt (34)–2
M10 x 58mm Button
Screw (19)–4
4
, and a rubber
M20 Wave
Washer (85)–2
M10 Nylon
Locknut (29)–2