Removing/Installing The Standard Back Upholstery; Removing - Invacare ProSPIN X4 Owner's Manual

Hide thumbs Also See for ProSPIN X4:

Table of Contents

SECURE THESE ENDS TOGETHER

Chest Positioning

Strap Half

Back Cane

FIGURE 9.4 Installing/Removing the Chest Positioning Strap

Removing/Installing the Standard Back Upholstery

NOTE: For this procedure, refer to FIGURE 9.5 on page 60.

1. Cut the tie‐wraps that secure the bottom of the existing back upholstery to the

wheelchair frame.

2. Remove the two mounting screws and washers that secure the existing back

upholstery to the back canes.

3. Remove the back height adjustment screw and locknut that secure one back cane to

the wheelchair frame.

NOTE: It may be necessary to pull the back upholstery up to reveal the back height adjustment

screw securing the back cane to the wheelchair frame.

NOTE: It is necessary to remove only one back cane to replace the back upholstery.

4. Pull the loose back cane out of the existing back upholstery.

5. Pull the existing back upholstery up and over the mounted back cane.

Part No 1125104

Chest Positioning Strap Half

Back Upholstery

Mounting Screws

Washer

SECTION 9—BACK

NOTE: Only hook and loop style

chest positioning strap shown.

Auto style chest positioning strap

attaches the same way.

Washer

Mounting Screws

ProSPIN™ X4™

Table of Contents