Adjusting Adjustable Angle Flip-Up Footplates; Adjusting Depth; Adjusting Angle - Invacare ProSPIN X4 Owner's Manual

Hide thumbs Also See for ProSPIN X4:

Table of Contents

SECTION 7—FRONT RIGGINGS

Adjusting Adjustable Angle Flip-up Footplates

WARNING

When determining the angle of the footplates, make sure the rear of the footplates

DO NOT interfere with the movement of the front casters. Otherwise, injury or

damage may occur.

NOTE: For this procedure, refer to FIGURE 7.3.

1. Remove the two flat screws and locknuts that secure footplate to the half clamp.

NOTE: Observe the angle of the footplate for reinstallation.

2. Move the footplate to one of four mounting positions.

NOTE: If desired depth is still not obtained, rotate the half clamp on the footplate hinge 180°.

3. Tighten the two flat screws and locknuts.

NOTE: The setting for positioning the footplate on the half clamp may vary for each footplate.

4. Repeat STEPS 1‐3 for opposite footplate, if desired.

1. Loosen, but DO NOT remove, the adjustment screw in the half clamp.

2. Position the footplate to the necessary angle to accommodate the user (Detail ʺAʺ of

FIGURE 7.3).

3. Retighten the adjustment screw. Torque to over 90 in‐lbs, but no more than 300 in‐lbs.

4. Repeat STEPS 1‐3 for opposite footplate, if desired.

90° Footrest Support

DETAIL "A" - SIDE VIEW OF

FOOTPLATE AND

FOOTREST SUPPORT

Flat Screws

Footrest Support

Footplate

Footplace

Half

Hinge

Clamp

Adjustment Screw

Locknuts

FIGURE 7.3 Adjusting Adjustable Angle Flip-up Footplates

ProSPIN™ X4™

Part No 1125104

Table of Contents