Adjusting the Flip-Up Footrest
NOTE: This procedure is for fixed front frames ONLY.
Adjusting Footplate Angle
When determining the angle of the footplate, make sure the rear of the footplate
does not interfere with the movement of the front casters.
NOTE: For this procedure, refer to FIGURE 7.4.
1. Loosen, but DO NOT remove the flat screws, washers and locknuts that secure the
footplate to the two footrest tubes.
2. Position the footplate to the necessary angle to accommodate the user.
3. Retighten the flat screws, washers and locknuts.
Adjusting Footplate Depth
NOTE: For this procedure, refer to FIGURE 7.4.
1. Remove the flip‐up footrest from the wheelchair. Refer to Installing Adjustable Angle
Flip‐up Footplate Hinge on page 41.
2. Loosen, but DO NOT remove the flat screws, washers and locknuts that secure the
footplate to the footrest tubes.
NOTE: Observe the angle of the footplate for reinstallation.
3. Move the footplate to one of two positions to accommodate the user. See Detail "A" of
FIGURE 7.4
4. Retighten the flat screws, washers and locknuts.
5. Reinstall the flip‐up footrest onto the wheelchair. Refer to Installing Adjustable Angle
Flip‐up Footplate Hinge on page 41.
Footrest Tube
Flat Screws
Footrest
Tube
Washers
FIGURE 7.4 Adjusting Footplate Angle - Adjusting Footplate Depth
Part No 1125104
WARNING
Footplate
Washers
43
SECTION 7—FRONT RIGGINGS
DETAIL"A" - DEPTH POSITIONS
Footplate
Position 1
Locknuts
Position 2
ProSPIN™ X4™