Installing Adjustable Angle Flip-Up Footplate Hinge - Invacare ProSPIN X4 Owner's Manual

Installing Adjustable Angle Flip-up Footplate Hinge

NOTE: For this procedure, refer to FIGURE 7.2.
NOTE: This procedure is for individual adjustable angle footrests only.
1. Position the adjustable angle flip‐up footplate hinge on the footrest support tube at the
desired height.
2. Using the mounting screw and locknut, loosely secure the adjustable angle flip‐up
foot plate hinge to the footrest support tube.
3. Flip the footplate hinge to the up position.
NOTE: The footplate hinge will fall to the down position.
4. Tighten the mounting screw and locknut that secure the footplate hinge to the footrest
support until the footplate hinge remains in the up position.
5. Check the up and down motion of the footplate hinge to make sure the user of the
wheelchair can operate the footplates easily.
NOTE: If the footplateʹs motion is too tight, loosen the socket screw and locknut approximately ¼‐
turn.
FIGURE 7.2 Installing Adjustable Angle Flip-up Footplate Hinge
Part No 1125104
Locknut
Footplate
Hinge
41
SECTION 7—FRONT RIGGINGS
Footrest
Support
Tube
Mounting
Screw
ProSPIN™ X4™