Section 14-Seat-To-Floor Height; Seat Dump - Invacare ProSPIN X4 Owner's Manual

SECTION 14—SEAT-TO-FLOOR HEIGHT
SECTION 14—SEAT-TO-FLOOR
HEIGHT
WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.

Seat Dump

NOTE: For this procedure, refer to FIGURE 14.1.
NOTE: Refer to Measuring Seat‐to‐Floor Height on page 92 for measuring instructions.
NOTE: Invacare recommends that the rear seat‐to‐floor height be AT LEAST 3/8‐inch shorter than
the front seat‐to‐floor height. Otherwise a forward seat dump can occur.
Subtract the rear seat‐to‐floor height measurement from the front seat‐to‐floor height
measurement to determine the amount of seat dump as shown in the example in
FIGURE 14.1.
Front
Rear
Seat-to-Floor Height
Seat-to-Floor Height
Example:
18¾ inches Front Seat-to-Floor Height
- 17 inches Minus Rear Seat-to-Floor Height
1¾ inches Equals Seat Dump
FIGURE 14.1 Seat Dump
91
Part No 1125104 ProSPIN™ X4™