Installing/Replacing Adjustable Back Upholstery
NOTE: For this procedure, refer to FIGURE 9.6 on page 62.
Installing
1. Remove the existing back upholstery from the wheelchair. Refer to Removing/
Installing the Standard Back Upholstery on page 59.
2. Slide each section (anchor loop/adjuster strap) of the adjustable back upholstery with
the grommet hole facing the rear of the wheelchair.
3. Secure the adjustable back upholstery to the back canes with the two mounting
screws.
NOTE: Clean the upholstery with warm water and mild detergent to remove superficial soil.
After the adjustable back upholstery has been positioned to the end-users individual
needs, the fastening straps MUST be securely fastened before applying the back
upholstery cover. The adjustable back should be checked whenever entering the
wheelchair to ensure that the fastening straps are securely fastened.
4. Slip adjuster straps through corresponding anchor loops and adjust the back
upholstery. Secure with the fastening straps.
5. Secure the back upholstery cover (fastening strap) to the back of the adjustable back
upholstery (fastening strap).
6. Flip the back upholstery cover over the adjustable back upholstery and secure the
fastening straps to the front of the adjustable back upholstery.
7. Lay the front portion of the back upholstery cover on the seat upholstery.
8. Adjust the slack in the back upholstery cover and then secure to the seat upholstery.
Replacing
1. Lift up on the existing back upholstery cover and remove the cover from the
wheelchair.
2. Remove the two mounting screws and washers that secure the existing adjustable
back upholstery to the back canes.
3. Slide each section (anchor loop/adjuster strap) of the existing adjustable back
upholstery off of the back canes.
4. Slide each section (anchor loop/adjuster strap) of the new adjustable back upholstery
with the grommet hole facing the rear of the wheelchair.
5. Secure new adjustable back upholstery to the back canes with the two mounting
screws and washers.
Part No 1125104
WARNING
61
SECTION 9—BACK
ProSPIN™ X4™