Adjusting the Back Height
NOTE: For this procedure, refer to FIGURE 9.2.
1. Remove the two back height adjustment screws and locknuts that secure the two back
canes to the wheelchair frame.
2. Reposition the back canes to one of five height adjustment holes.
NOTE: Both back canes should be adjusted to the same adjustment hole.
3. Reinstall the two back height adjustment screws and locknuts that secure the back
canes to the wheelchair frame.
Back Height
Adjustment
Screw
Locknut
Adjusting the Back Angle
NOTE: For this procedure, refer to FIGURE 9.3 on page 58.
NOTE: This procedure applies to adjustable angle backs only.
NOTE: The back adjusts to four positions in five degree increments from 0° to 15°.
1. Remove the two back angle adjustment screws and locknuts.
2. Reposition the back to the desired angle.
3. Ensure the upper back angle mounting hole is aligned with one of the four upper
angle adjustment holes.
4. Install one of the back angle adjustment screws through the upper back angle
mounting hole and the desired upper angle adjustment hole.
Part No 1125104
Back Upholstery
Back Height
Adjustment
Locknut
FIGURE 9.2 Adjusting the Back Height
*NOTE: Holes numbered for
reference only. (There are no
numbers on the wheelchair
frame or back canes.)
Back Height
Adjustment
Holes*
1
2
3
4
5
Screw
57
SECTION 9—BACK
Back
Cane
Wheelchair
Frame
ProSPIN™ X4™