Adjusting The Height Of The Center Mount Footrest - Invacare Formula Powered Seating Owner's Operator And Maintenance Manual

Adjusting the Height of the Center Mount Footrest

While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 6.16.
1. Remove the two mounting screws that secure the footrest extension tube to the
extension tube housing.
2. Adjust the footrest extension tube to the desired height and align the corresponding
holes to the mounting holes on the extension tube housing.
3. Reinstall the two mounting screws to secure the footrest extension tube to the
extension tube housing. Securely tighten.
4. Repeat STEPS 1-3 for the other extension tube.
Extension Tube Mounting Holes
FIGURE 6.16 Adjusting the Height of the Center Mount Footrest
Part No 1122170
All manuals and user guides at all-guides.com
WARNING
Mounting Screws
Height Adjustment
Holes
47
SECTION 6—FRONT RIGGINGS
Seat Frame
Release Lever
Extension
Housing
Extension Tube
Formula™ Powered Seating