Procurve 2650 Leds And Buttons; Hp Procurve 2650; Procurve 2650 Leds; Procurve Led Identification - HP Cluster Platform Interconnects v2010 Manual

The HP ProCurve 2650 has a power connector, but it does not have a power switch. It is powered
on when connected to an active AC power source. The automatically adjusts to any voltage
between 100 volts and 240 volts (50–60 Hz). No voltage range settings are required.
The console port on the back of the ProCurve 2650
cable. Use a PC or a workstation running a VT-standard terminal interface for the console.
Figure 2-2 HP ProCurve 2650 Rear View
Console
1
The list below corresponds to the callouts in
1. Console port connector
2. Cooling vent
3. AC power inlet
Note:
The ProCurve 2650 has two cooling vents, which must not be obstructed for proper switch
operation.
Note:
The HP ProCurve 2650 is installed in the rack with the back side facing the front of the rack.

2.2 ProCurve 2650 LEDs and Buttons

The front panel of the ProCurve 2650 has seven types of LEDs, as described in
rear panel of the ProCurve 2650 does not have any LEDs.
Figure 2-3 ProCurve 2650 LEDs
1 3 4
2
6 5
Table 2-1 ProCurve LED Identification
Item Description
1 Power
2 Fault
2
Figure 2-2
State Meaning
Green On = The switch is receiving power.
Off = The switch is not receiving power.
Orange On = The switch has encountered a fatal hardware failure or has failed its
self-test.
(Figure 2-2) connects to a console via a serial
2.2 ProCurve 2650 LEDs and Buttons
3
Table 2-1. The
7
19