Procurve 5308Xl Rear View - HP Cluster Platform Interconnects v2010 Manual

Table 5-1 Switch Chassis LEDs (continued)
LEDs
Status/Fan (green)
Status/Power (green -
numbers corresponding
to the power supply
positions)
Status / Modules (green
- letters corresponding
to the switch module
slots)
LED Mode Select (3
green LEDs)

5.1.2 ProCurve 5308xl Rear View

The rear of the ProCurve 5308xl
power switch. It is powered on when connected to an active AC power source, and automatically
adjusts to any voltage between 100-127 and 200-240 volts and either 50 or 60 Hz. There are no
voltage range settings required.
36 HP ProCurve 5308xl
State Meaning
A component of the switch has failed its self test. The Status LED for
that component, for example a switch module, and the switch Fault
Flashing LED will flash simultaneously.
On The cooling fans are operating normally.
One or more of the cooling fans have failed. The switch Fault LED will
Flashing be flashing simultaneously.
A power supply is installed in the position in the back of the switch
corresponding to the number, and the supply is plugged in to an active
AC power source. As shipped, the switch has a single power supply in
On position 1.
A power supply is not installed in the position corresponding to the
Off number.
The power supply installed in the position corresponding to the number
is not plugged in to an active AC power source, or has experienced a
Flashing fault. The switch Fault LED will be flashing simultaneously.
A module is installed in the switch module slot corresponding to the
letter and the module is undergoing or has passed self test. This also
occurs when you hot swap a module when the switch is already powered
On on.
A module is not installed in the switch module slot corresponding to
Off the letter.
The module status LED flashes very briefly when a module is being hot
swapped. If the LED flashes for a prolonged time, the module in the
slot corresponding to the letter has failed self test or encountered some
Flashing other fault condition.
Indicates that the port Mode LEDs are displaying network activity
Act information.
Indicates that the port Mode LEDs are lit for ports that are in Full Duplex
FDx Mode.
Indicates that the port Mode LEDs are lit for ports that are operating at
their maximum possible link speed -- for any Gigabit-capable connection,
that would be 1000 Mbps; for the 10/100-TX ports and 100-FX ports, that
Max would be 100 Mbps.
Indicates that specific error packets are being detected on the port. In
this mode, the Mode LED for the port will flash briefly for each error
! packet that is detected, for example CRC errors or late collisions.
(Figure 5-2) has an AC power connector. It does not have a