Fc Mode - HP 6125XLG Command Reference Manual

Table 3 Command output
Field
The brief information of
interface(s) under bridge mode
Link: ADM - administratively
down; Stby - standby
Speed or Duplex: (a)/A - auto; H -
half; F - full
Interface
Link
Speed
Duplex
Type
PVID
Description

fc mode

Use fc mode to configure the operating mode of a VFC interface.
Use undo fc mode to restore the default.
Description
Brief information about Layer 2 interfaces.
•
ADM—The interface has been shut down by the network administrator.
To recover its physical layer state, execute the undo shutdown
command.
•
Stby—The interface is a standby interface.
For speed:
(a)—The interface rate is determined by autonegotiation.
For duplex:
•
(a)/A—The interface duplex mode is determined by autonegotiation.
•
H—Half duplex.
•
F—Full duplex.
Interface name.
Physical link state of the interface:
•
UP—The link is physically up.
•
DOWN—The link is physically down.
•
ADM—The link has been administratively shut down. To recover its
physical state, execute the undo shutdown command.
•
Stby—The interface is a standby interface.
Interface rate in bps.
Duplex mode of the interface:
•
A—The duplex mode is determined by autonegotiation.
•
F—Full duplex
•
F(a)—Full duplex as the result of autonegotiation.
•
H—Half duplex.
•
H(a)—Half duplex as the result of autonegotiation.
Link type of the interface:
•
A—Access.
•
H—Hybrid.
•
T—Trunk.
Port VLAN ID (PVID).
Interface description configured by using the description command.
Without the description keyword, the display interface brief command
displays a maximum of 27 characters of the description. With the
description keyword, this command displays all of the description.
7