Default - HP 6125XLG Command Reference Manual

You can use the display fcoe command to display the FCoE MAC address of a switch. You can display
the FCoE MAC address of an ENode through some software or the NMS.
A VFC interface can be bound to only one Layer 2 Ethernet interface and to only one FCoE MAC
address.
A Layer 2 Ethernet interface can be bound to multiple VFC interfaces, but an FCoE MAC address can be
bound to only one VFC interface.
If you bind one VFC interface to a Layer 2 aggregate interface and another VFC interface to a Layer 2
Ethernet interface that is a member port of the Layer 2 aggregate interface, the binding to the Layer 2
aggregate interface does not take effect.
Examples
# Bind interface VFC 4 to Layer 2 Ethernet interface Ten-GigabitEthernet 1/1/5 and FCoE MAC address
000c-2999-eacd.
<Sysname> system-view
[Sysname] interface vfc 4
[sysname-Vfc4] bind interface ten-gigabitethernet 1/1/5 mac 000c-2999-eacd
Related commands
• display fcoe
display interface vfc
•

default

Use default to restore the default settings for a VFC interface.
Syntax
default
Views
VFC interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies or system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings for interface VFC 1.
<Sysname> system-view
[Sysname] interface vfc 1
3