Hardware-Count Enable - HP 6125G Command Reference Manual

Table 5 Command output
Field
Current time
Time-range

hardware-count enable

Syntax
hardware-count enable
undo hardware-count enable
View
IPv4 basic/advanced ACL view, IPv6 basic/advanced ACL view, Ethernet frame header ACL view
Default level
2: System level
Parameters
None
Description
Use hardware-count enable to enable counting ACL rule matches performed in hardware. The device
automatically counts the rule match counting performed in software.
Use undo hardware-count enable to disable counting ACL rule matches performed in hardware. This
command also resets the hardware match counters for all rules in the ACL. For a rule configured with the
counting keyword, this command only resets the rule's hardware match counter.
By default, ACL rule matches performed in hardware are not counted.
The hardware-count enable command enables match counting for all rules in an ACL, and the counting
keyword in the rule command enables match counting specific to rules. For an individual rule, rule match
counting works as long as either the hardware-count enable command or the counting keyword is
configured.
When an ACL is referenced by a QoS policy, this command or the counting keyword does not take effect.
No ACL rule matches are counted.
Related commands: display acl, display acl ipv6, and rule.
Examples
# Enable rule match counting for IPv4 ACL 2000.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] hardware-count enable
# Enable rule match counting for IPv6 ACL 2000.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] hardware-count enable
Description
Current system time
Configuration and status of the time range, including its name,
status (active or inactive), and start time and end time
13