Acl Configuration Commands; Acl - HP 6125G Command Reference Manual

ACL configuration commands

acl

Syntax
acl number acl-number [ name acl-name ] [ match-order { auto | config } ]
undo acl { all | name acl-name | number acl-number }
View
System view
Default level
2: System level
Parameters
number acl-number: Specifies the number of an access control list (ACL):
• 2000 to 2999 for IPv4 basic ACLs
3000 to 3999 for IPv4 advanced ACLs
•
4000 to 4999 for Ethernet frame header ACLs
•
name acl-name: Assigns a name to the ACL for easy identification. The acl-name argument takes a
case-insensitive string of 1 to 63 characters. It must start with an English letter, and to avoid confusion,
cannot be all.
match-order: Sets the order in which ACL rules are compared against packets:
auto—Compares ACL rules in depth-first order. The depth-first order differs with ACL categories. For
•
more information, see ACL and QoS Configuration Guide.
config—Compares ACL rules in ascending order of rule ID. The rule with a smaller ID has higher
•
priority. If no match order is specified, the config order applies by default.
all: Deletes all IPv4 ACLs and Ethernet frame header ACLs.
Description
Use acl to create an IPv4 ACL or an Ethernet frame header ACL, and enter its view. If the ACL has been
created, you enter its view directly.
Use undo acl to delete the specified IPv4 or Ethernet frame header ACL, or all IPv4 and Ethernet frame
header ACLs.
By default, no ACL exists.
You can assign a name to an IPv4 or Ethernet frame header ACL only when you create it. After an ACL
is created with a name, you cannot rename it or remove its name.
You can change match order only for ACLs that do not contain any rules.
To display any ACLs you have created, use the display acl command.
Examples
# Create IPv4 basic ACL 2000, and enter its view.
<Sysname> system-view
1