Configuring Radius Accounting - HP ProCurve 6120G/XG Manual

Configuring RADIUS Accounting

RADIUS Accounting Commands
[no] radius-server host < ip-address >
[no] aaa accounting < exec | network | system | commands>
[no] aaa accounting update
[no] aaa accounting suppress null-username
show accounting
show accounting sessions
show radius accounting
Note
This section assumes you have already:
■
■
If you have not already done so, refer to "General RADIUS Setup Procedure"
on page 5-7 before continuing here.
RADIUS accounting collects data about user activity and system events and
sends it to a RADIUS server when specified events occur on the switch, such
as a logoff or a reboot. The switches covered in this guide support four types
of accounting services:
■
[acct-port < port-number >]
[key < key-string >]
< start-stop | stop-only> radius
periodic < 1 - 525600 > (in minutes)
Configured RADIUS authentication on the switch for one or more
access methods
Configured one or more RADIUS servers to support the switch
Network accounting: Provides records containing the information
listed below on clients directly connected to the switch and operating
under Port-Based Access Control (802.1X):
• Acct-Authentic
• Acct-Delay-Time
• Acct-Input-Octets
• Acct-Input-Packets
• Acct-Output-Octets
• Acct-Output-Packets
RADIUS Authentication, Authorization, and Accounting

Configuring RADIUS Accounting

• Acct-Session-Id • MS-RAS-Vendor
• Acct-Session-Time • NAS-Identifier
• Acct-Status-Type • NAS-IP-Address
• Acct-Terminate-Cause • NAS-Port
• Called-Station-Id • Service-Type
• HP-acct-terminate- • Username
cause
Page
5-50
5-50
5-50
5-54
5-54
5-54
5-59
5-60
5-60
5-47