Configure The Switch's Global Radius Parameters - HP ProCurve 6120G/XG Manual

2.
Figure 5-4. Sample Configuration for RADIUS Server Before Changing the Key and
Adding Another Server
To make the changes listed prior to figure 5-4, you would do the following:
Figure 5-5. Sample Configuration for RADIUS Server After Changing the Key and Adding Another Server
To change the order in which the switch accesses RADIUS servers, refer to
"Changing RADIUS-Server Access Order" on page 5-60.

4. Configure the Switch's Global RADIUS Parameters

You can configure the switch for the following global RADIUS parameters:
Add a RADIUS server with an IP address of 10.33.18.119 and a server-
specific encryption key of "source0119".
RADIUS Authentication, Authorization, and Accounting
Configuring the Switch for RADIUS Authentication
Changes the key
for the existing
server to
"source0127"
(step 1, above).
Adds the new
RADIUS server
with its required
"source0119" key.
Lists the switch's
new RADIUS
server
configuration.
Compare this with
5-17