Cli Commands Described In This Section; Viewing The Switch's Current Authentication Configuration - HP ProCurve 6120G/XG Manual

CLI Commands Described in this Section

Command
show authentication
show tacacs
aaa authentication
tacacs-server
Viewing the Switch's Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax:
This example shows the default authentication configuration.
Figure 4-2. Example Listing of the Switch's Authentication Configuration
Page
4-9
4-10
4-11 through 4-17
console
Telnet
num-attempts <1-10 >
4-18
host < ip-addr > 4-18
key 4-22
timeout < 1-255 > 4-23
show authentication
TACACS+ Authentication
Configuring TACACS+ on the Switch
Configuration for login and enable access
to the switch through the switch console
port.
Configuration for login and enable access
to the switch through Telnet.
4-9