HP ProCurve 6120G/XG Manual page 599

shared secret key, saving to configuration
file ... 2-11, 2-15
show accounting ... 5-59
show authentication ... 5-58
SNMP access security not supported ... 5-4
SNMP access to auth config MIB ... 5-4
statistics, viewing ... 5-56
terminology ... 5-5
TLS ... 5-6
Tunnel-Type attribute ... 5-44
vendor specific attributes ... 5-45
vendor-specific attributes ... 5-37, 6-4
VSAs ... 5-38
web browser security not supported ... 5-7
web-browser access controls ... 5-34
web-browser security not supported ... 5-4, 5-34
RADIUS-assigned ACLs ... 6-9
802.1X port-based access ... 6-17
802.1X user-based access ... 6-17
ACE, defined ... 6-9
application type ... 6-10
contrasting dynamic and static ... 6-13
DA, defined ... 6-10
defined ... 6-9
definitions ... 6-9
deny any, implicit, switched packets ... 6-16
deny, defined ... 6-10
dynamic port ACL ... 6-10
dynamic port ACL, effect ... 6-17
filters ... 6-13
implicit deny, defined ... 6-10
inbound traffic, defined ... 6-10
inverse mask
See wildcard.
mask ... 6-10
mask, defined ... 6-10
multiple application types in use ... 6-15
multiple clients, access restriction ... 6-17
multiple dynamic ACLs ... 6-17
outbound traffic, defined ... 6-10
permit, defined ... 6-11
resource monitor ... 6-30
See also ACLs.
source routing, caution ... 6-14
standard attribute ... 6-18
static-port ACL ... 6-11
switched packets ... 6-16
terminology ... 6-9
terms ... 6-9
vendor-specific attribute ... 6-18
wildcard ... 6-10, 6-11
wildcard, defined ... 6-11
rate-limit
override ... 12-63
rate-limiting ... 10-34
RADIUS administered ... 5-4
RADIUS override ... 6-7
RADIUS server specified ... 6-6
RADIUS server support ... 6-4
RADIUS-assigned vs. applied ... 6-5
RADIUS-assigned, increments ... 6-5
remote-id
changing ... 10-11
snooping ... 10-10
reserved port numbers ... 7-19, 8-20
Reset-on-clear
disabled when saving security credentials to
configuration file ... 2-20
RFCs
RFC 2548 ... 5-45
RFC 3580 ... 5-44
RFC 4675 ... 5-44
routing
source-routing, caution ... 6-14, 9-12, 9-33
RSA key, cert ... 7-11
S
security
authorized IP managers ... 14-1
per port ... 13-3
security credentials
802.1X credentials saved to configuration
file ... 2-14, 2-21
copying configurations on the switch ... 2-20
copying startup configuration ... 2-19
disabling Reset-on-clear option ... 2-20
downloading a configuration file ... 2-19
downloading from a server ... 2-10
enabling storage in configuration file ... 2-11
manager username and password ... 2-12
operator username and password ... 2-12
RADIUS ... 2-15
saving to running configuration with include-
credentials ... 2-19
saving to startup configuration ... 2-19
Index – 11