HP ProCurve 6120G/XG Manual page 140

Web and MAC Authentication
Configuring MAC Authentication on the Switch
Syntax:
ProCurve (config)# show port-access mac-based
Port Access MAC-Based Status
Auth
Port Clients Clients VLAN
---- ------- ------- -------- ------
1 1
2 2
3 4
Figure 3-31. Example of show port-access mac-based Command Output
3-56
show port-access mac-based [port-list]
Displays the status of all ports or specified ports that are
enabled for MAC authentication. The information displayed
for each port includes:
• Number of authorized and unauthorized clients
• VLAN ID number of the untagged VLAN used. If the switch
supports MAC-based (untagged) VLANs, MACbased is
displayed to show that multiple untagged VLANs are
configured for authentication sessions.
• If tagged VLANs (statically configured or RADIUS-
assigned) are used (Yes or No)
• If client-specific per-port CoS (Class of Service) values are
configured (Yes or No) or the numerical value of the CoS
(802.1p priority) applied to all inbound traffic. For client-
specific per-port CoS values, enter the show port-access
web-based clients detailed command.
• If per-port rate-limiting for inbound traffic is applied (Yes
or No) or the percentage value of the port's available
bandwidth applied as a rate-limit value.
Information on ports not enabled for MAC authentication is
not displayed.
Unauth Untagged Tagged
VLANs
1 2003 Yes
0 MACbased No
0 1 Yes
Port Cntrl
COS Dir
-------- ------
70000000
Yes
No